Nanolex Si3D HD (Approved Detailers Only)

Si3D HD is available to purchase by Nanolex Approved Detailers only. Any orders received from non-certified individuals will be cancelled and refunded.

• Become an accredited detailer

IMPORTANT: Before you use Nanolex Car Care products, please make sure you wear suitable protection gear – we always recommend to use Nitrile gloves to make sure your hands are protected from any possible damage to your skin.

Consumption: Sealant: appr. 6ml/m² (~50 ml for paint + rims) Wash applicator cloths as well as all microfibre cloths before using them.

Processing temperature: 5-30°C - Avoid direct sunlight and/or high air humidity.

• Nanolex Si3D HD can be applied directly to all clear-coated (lacquered) surfaces. The lacquer surface must be dry and free of contamination or dust. We strongly recommend using Nanolex EX directly before the application to make sure that all oils/fillers and other dirt are removed completely from the surface. Use Nanolex microfibre towels and turn or exchange frequently during cleaning/polishing.
• If the car was machine polished before the application it is necessary to remove any (mostly invisible) fillers and oils – if those are not removed a white or grey hazing will appear on the paint once Si3D HD is applied. The paint sealant layer itself is too thin to be visible and can easily be buffed off – only fillers and oils will become visible. We recommend washing the car with Nanolex PreWash after machine polishing to safely remove the majority of contamination.
• Spread 5-6 drops/m2 of Nanolex Si3D HD on a microfiber applicator pad and apply it sparingly by rubbing in with light pressure in criss-cross motions until all of the product is evenly distributed and only minimal residue is visible. Remove the coating residue with a soft microfibre cloth after a maximum of 3 minutes. There is no pressure necessary to remove it completely. It is possible to apply multiple layers of Si3D HD, if you do so, make sure to apply immediately after each other, or at most 10 minutes after the previous layer application.
• Let Nanolex Si3D HD cure on the surface for at least 12 hours (at ambient temperature, assuming 20°C) before the first water contact. Do not wash the car within the first 72 hours.

Curing time depending on temperature: @50°C: 3-4 hours @80°C: 2 hours

Sizes: 30ml & 50ml (Select from drop down menu above)